|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a high quality manual with clear schematic and components layout diagrams ; with service procedure included.
 ;
This service manual for the Kenwood KT-990D was reproduced really well ,is very legible and manual is complete.Combined with the low price paid,in the future,I will be checking Owner-Manuals.com any time I need a manual.
 ;
When I purchased this manual I had my doubts regarding the quality as the price was so reasonable as compared to other outlets.
The manual itself is of high standard the print is very clear as are the diagrams. Obviously with the diagrams one has to zoom in otherwise it is to small to be able to read.
Overall I am very pleased with the company who delivered as they said and with the manual they supplied.
I occasionally require a manual and now having registered with this company I shall order from them in the future.
 ;
I was at first dubious about payiong for downloaded manuals but having done so, I was extremely impressed with quality of the two manual I ordered, well worth the small price I paid.
I would highly recommend these to my friends.
 ;
reasonable price for the schematic - the service is perfect, all as expected and pointed by instructions - good scan of the original plans - thank you!
X-NM30VCD, XR-NM3V
7 CD MECHA-2
CD Tray Open (Gear Load Aat the lower left of amechanism is turned to the left.)
Remove to the CLAMPER
A finger is put into the bottom of CHASSIS and CLAMPER is pushed from the bottom. The end of CLAMPER is united with the cut in right and left of CHASSIS, and the upper surface of CLAMPER is raised by hand and turned counterclockwise.
7 DIAGNOSIS OF CD MECHA ASSY
When diagnosing the CD MECHA Assy, use the following Flexible Cable and Connector Assys for service. Motor Assy - VCD PWB Assy ( 6 pin Flexible Cable) : No. GGD1275
When removing a tray, a stopper is raised upwards and a tray is pulled.
1
2
Control Assy - VCD PWB ASSY 27P Flexible Cable : No. GGD1237 A tray is attached, and a tray is put in at the time, making it move to the right for a while so that a cam slider may be gone into the slot on the tray.
62
|
|
 |
> |
|