|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Complete service manual in very good scanning quality with all schematic and PWB graphics as well as assembly & maintenance instructions. A slight drawback is that the rastering of the PWB graphics sometimes makes it a bit difficult to follow fine traces, but no showstopper.
;
Purchased the manual that I was looking for at a great price and could download it easily.. Great service experience and for future purchases I plan to use the site. Thank you very much
 ;
Service manual in good quality, it was very helpful to me. Perfect service, I am very satisfied.
Jochen Kelm
;
Exellent manual ,it was in great condition,and got all the info i expected,5 stars!!
;
I searched the Internet exhaustively for this manual and Owner-Manuals was the least expensive...but provided an excellent reproduction within 4 hours. Very satisified.
XS-R9
4. Clamp Cam
(1) Remove the Float Base. (Refer to paragraph 3.) (2) Remove the Gear Pulley and Drive Gear. (3) Pull it up after you turn the Clamp Cam to the counterclockwise direction fully.
REMIX EFFECTOR [EF-R9 (S)]
1. MAIN ASSY (Fig.1)
(1) Remove the Bonnet (three screws of the rear part). (2) Remove the seven screws A that MAIN ASSY is fixed, and unhook two Hooks B . (Fig.1). (3) Remove the MAIN ASSY C .
5. How to Attach the Clamp Cam
(1) Attaches the Clamp Cam with pushing down Lever Switch on the Loading Base to the loft side.
B B C A A A A A
MAIN Assy
6. How to Attach the Float Base
(1) It turns Clamp Cam to the counterclockwise direction fully, and attach the Float Base. (As for the details of the way of turning Clamp Cam, refer to paragraph 3.) Remove the Float Base.
A A
Fig. 1
7. How to Attach the Tray
(1) Turns the Drive Gear to the counterclockwise direction, and lowers the Servo Mechanism Assy fully. (2) Turn the Drive Gear to the counterclockwise direction, and engage of Drive Gear and the mark E of Loading Base. (3) Insert the tray. Note 1: Gear doesn't engage when Servo Mechanism Assy doesn't fall down even if Drive Gear rotates. Perform step (2) in this case, and it turns Drive Gear one more time. Note 2: Servo Mechanism Assy isn't raised fully when Tray isn't being inserted completely. When it is received, a power supply is raised to the Servo Mechanism Assy automatically.
2. Front Panel (Fig.2)
(1) Remove the Bonnet (three screws of the rear part). (2) Remove the two screws D which fixes Front Panel. (3) Unhook the two Hooks E which fixes Front Panel, and make Front Panel slide into the front, and remove Front Panel.
Front Panel
Front Panel
D
E Hook
E Hook D
Right side Fig. 2
Left side
63
|
|
|
> |
|
