|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It´s very very nice manual with all, what i need. Original in good quality. Very fast business. Very much thanks...
;
Purchased the manual that I was looking for at a great price and could download it easily.. Great service experience and for future purchases I plan to use the site.
Thank you very much
;
Exactly what was needed to assess the product - excellent value and great service
;
A site where discontinualed schematic diagrams and back dated information can be found on discontinued radios tv's and any electronic equipment can be found. Newer manuals either Service and operating manuals. Radio amateurs should find this site a great source for ham radio equipment manuals. I will return to this site should I need information on any electrical equipment. priced easy to download in a PDF format and print pages need to undertake the repair.
;
Quality scan of the original. All the detail necessary to troubleshoot, repair and adjust the unit. I'm sure I will be downloading more manuals in the future as the need arises.
XT-XM1 SECTION 2 GENERAL
Installingthe unit
�Mount the unit either inside the trunk or under a seat. �Choose the mounting location carefully so the unit will not interfere with the normal movements of the driver and it will not be exposed to direct sunlight or hot air from the heater. �Do not install the unit under the floor carpet, where the heat dissipation from the unit will be considerably impaired. First, place the unit where you plan to install it, and mark the positions of the four screw holes on the mounting surface. 1 1
This section is extracted from instruction manual.
Screw hole: ø3.3 mm (5/32 in.)
Notes � Use only the supplied screws. � Be sure not to damage the fuel tank or brake line with the tapping screws.
Fuse replacement
If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction.
Warning
Use a fuse with the specified amperage rating. Use of a higher amperage fuse may cause serious damage.
Connection
Connectionexample Cautions
� This unit is designed for negative ground 12 V DC operation only. � Before making connections, turn the car ignition off to avoid short circuits. � Connect the yellow power input cord only after all other cords have been connected. � Run all ground leads to a common ground point.
XM Antenna*
Sony BUS Compatible Car Audio*
XT-XM1
CD/MD changer*
* not supplied
Connectiondiagram
Connect with BUS cable to the XM Satellite receiver, aligning the v marks.
Note When you use an optional BUS cable, note that a BUS cable with an 8-pin plug (L-type) cannot be used because of its shape.
SONY BUS CONTROL
AUDIO
ANTENNA
POWER
OUT
IN
L
OUT
R
L
IN
R
TER
SAT
Green
2 Connect as the connector hook facing down
Yellow (Curry)
XM antenna (not supplied)
RCA pin cord (not supplied) To a +12 V power terminal which is energized at all times Be sure to connect the black ground lead to it first. Fuse (3 A) Yellow
OUT
CD/MD changer (not supplied)
BUS cable (not supplied) 4
OUT IN
To a metal point on the car First connect the black ground lead, then connect the yellow power input leads.
Black 3 IN
Sony BUS Compatible Car Audio (not supplied)
3
 $4.99 XT-XM1 SONY
Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|
