|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
 ;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
;
This manual is very well presented and after printing out looks about as close to an original as I think you can get. The quality is second to none.
The content of the manual is comprehensive and I think it would be well suited to an audio repair professional which I'm not but I did find it very informative and helpful.
The cost of the manual is more than covered by the money I'll save when I change the keep memory battery now I have the relavant info.
Very pleased with my purchase and can recommend it wholeheartedly as I can other manuals I've downloaded from this site.
Regards
Limey Alex
;
Complete manual including mechanical part in good pdf quality. Shaded greys of the pcb due to pdf not perfect but usable.
XV-C3SL 3.2 Traverse mechanism assembly section 3.2.1 Removing the feed motor assembly (See Fig.12) (1) Unsolder the two soldering j on the spindle motor board. (2) Remove the four screws F attaching the feed motor assembly.
Fig.12 3.2.2 Removing the feed motor (See Fig.12 to 14) � Prior to performing the following procedure, remove the feed motor assembly. (1) Remove the screw G attaching the thrust spring. ATTENTION: When reattaching the thrust spring, make sure that the thrust spring presses the feed gear (M) and the feed gear (E) reasonably. (2) Remove the feed gear (M). (3) Pull out the feed gear (E) and the lead screw. (4) Remove the two screws H attaching the feed motor. ATTENTION: When reattaching, pass the two cables extending from the feed motor through the notch k of the feed holder as shown in Fig12. Fig.13
Fig.14
14
 $4.99 XV-C3SL JVC
Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|
