Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
Text excerpt from page 18 (click to view)
Getting started
To connect to an amplifier/receiver equipped with 5.1-channel inputs
The unit supports the linear PCM multichannel format of DVD Audio and can feed multichannel audio output signals from the 6 ANALOG AUDIO OUT jacks. It is also equipped with the DTS and Dolby digital decoders. So you can enjoy any type of the high quality surround sounds by connecting the unit to an amplifier/receiver equipped with the 5.1-channel inputs. Connect the unit�s ANALOG AUDIO OUT jacks to the analog 5.1-channel inputs of an amplifier or receiver using the supplied audio cables. Red Red Yellow
The unit
FRONT
LEFT LEFT
RIGHT
RIGHT
ANALOG DIGITAL PCM/STREAM
OPTICAL COAXIAL
SUBWOOFER
VIDEO S-VIDEO AV
White
REAR
Red
CENTER
Amplifier or receiver
AUDIO OUT AV COMPU LINK
VIDEO OUT
CENTER
AUDIO IN
White Getting started
SUBWOOFER
Red White White White Yellow Red White Audio cable (supplied) Red Audio/video cable (supplied) Audio cable (supplied)
REAR LEFT RIGHT FRONT LEFT RIGHT
� Be sure to connect correctly between corresponding terminals. The order of the 5.1-channel terminals depend on units.
NOTE
� When using the 5.1-channel outputs of the unit, set the �DOWN MIX� in the �PREFERENCE 2� on-screen display to �OFF� and select �5.1 CHANNEL� or �EXPERT� in the �SPK.SETTING� on-screen display. If the �EXPERT� is selected, you can control the audio output balance of the speakers (see pages 42 and 44).
