|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good manual for Technics SL 303. Manuale molto utile.
;
About one hour after checkout, the manual was available for download. Clear reading and detailed. Thanks
;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
 ;
We received the manual in a timely manner and it was exactly what we were expecting.
1
2
3
4
A
2 DVD Error Rate Adjustment
Notes: · Use disc: GGV1025
· Play the DVD test disc at inner track (around #30000)
START
· Play the DVD test disc at inner track · Display ERROR RATE on the monitor
B
ESC CHP/TIM
G N
Traverse Mechanism Assy-S Adjust the radial adjustment screw so that ERROR RATE becomes around "5E-4". A ERROR RATE : "5E-4"
Traverse Mechanism Assy-S Fasten the radial adjustment screw so that ERROR RATE becomes around "1E-3". B ERROR RATE : "1E-3"
1E-3
ERROR RATE
C A A
B
5E-4
· Unfasten the radial adjustment screw by 90 degrees step till ERROR RATE becomes around "1E-3" again . C · Record the number of rotation (N1).
(memorizing how much the screw was rotated.)
Best point
C
Anticlock wise Clock wise Rotation of Radial screw and Tangential screw
· Fasten the radial adjustment screw till the number of rotation becomes harf of N1. Best Radial point
ERROR RATE: - - - -
ESC
Player Monitor
D
Service mode end
· Play the DVD test disc at outer track (around #200000) Service mode
ESC CHP/TIM
Turn the POWER OFF in case of NG once, and perform the adjustment once again.
If error rate is OK, locks a root of tangential and radial adjustment screws with
E
CHECK
OK
In this check, the error rate that is less than "5E-5"is better.
the Screw tight. Screw tight: GYL1001
Traverse Mechanism Assy-S Fasten the tangential adjustment screw so that ERROR RATE becomes around "1E-3". B ERROR RATE : "1E-3"
Disc playback normally. · The measurement of block error rate
ESC CHP/TIM
F
ESC
· Unfasten the tangential screw by 90 degrees step till ERROR RATE becomes around "1E-3" again . C · Record the number of rotation (N1).
Service mode end
· Fasten the tangential adjustment screw till the number of rotation becomes half of N1. Best tangential point
44
1 2
XV-DV370
3 4
|
|
|
> |
|
