|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I found this manual to be complete in every detail. Besides the schematic it has a complete set of alignment instructions which are easy to understand. It also includes a complete parts list as well as an explanation of how the power supply and safety shutdown circuits operate. Even a schematic of the tuner is included.
 ;
The product was good and just what I needed, however I had moderate difficulty with the down load because the sight would not recognize my pass word. I was finally given a direct link to the manual and that worked.
;
Very quick and easy website to use and fast download of manual, quality of manual is excellent and will be pleased to use this service again in the future, thanks so much!
;
It is an very good and clear scanned service manual.
very recommended.
;
Easy to order the manual. Good quality and fast delivery.
1
2
3
4
5 Tray panel
A
Firstly remove the tray panel to remove the mecha. section. In this section, explain a disassembly of the tray panel.
How to open the tray when the power cannot be on
Insert a screwdriver (small) into the slit located at the bottom of the unit, and slide the projection of the drive gear in the LOADING MECHA. Assy in the direction of the arrow, as indicated in the photo. If the tray pops out a little, fully pull it out by a hand.
1 2 3 4 5 6
B
Remove the top panel and top plate. (See Step ¥.) Press the STANDBY/ON button to turn on the power.
Press the 0 (OPEN/CLOSE) button to open the tray. Remove the tray panel. Press the 0 (OPEN/CLOSE) button to close the tray. Press the STANDBY/ON button to turn off the power.
Slit
26
4
C
Tray
35
Screwdriver (small)
3
5
Tray panel
7
Disassembly of after step 7, refer to "Step [ DVDM Assy" . Projection
Screwdriver (small)
D
Drive gear LOADING MECHA. Assy
E
F
108
1 2
XV-DV99
3 4
|
|
|
> |
|
