The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
Text excerpt from page 16 (click to view)
Getting started
Getting started
To connect to a TV with the SCART connector
You can enjoy using the unit by simply connecting it to your television set with a 21-pin SCART cable. To hear audio sound with better quality, connect the audio output to your audio equipment.
The unit
DIGITAL OUT
PCM / STREAM COAXIAL
SCART cable (not supplied)
VIDEO OUT
VIDEO OUT AV Y/C COMP.
AV COMPU LINK
OPTICAL
VIDEO OUT
S-VIDEO
VIDEO
RIGHT
AUDIO OUT
LEFT
TV
IN S-VIDEO VIDEO
LEFT RIGHT
AV
IN
AUDIO
Set the COMP-Y/C switch correctly according to your TV. � If the TV only accommodates the composite video signal, set the switch to �COMP .� � If the TV accommodates the Y/C signals, set the switch to �Y/C� so that you can enjoy better-quality pictures. � If the TV accommodates the RGB signals, set the switch to �COMP� as well as make the unit feed the RGB signals by , following the procedure shown below.
How to make the unit feed the RGB signals
The unit cannot output the RGB signals from the SCART connector and the S-video (Y/C) signals from the S-VIDEO jack simultaneously. In the initial (factory-preset) condition, the S-VIDEO jack is active, while the RGB signals cannot be output. To make the unit feed the RGB signals, follow the procedure below. Note that the S-VIDEO jack does not feed correct signals when the unit is set to output the RGB signals.
% When the unit is turned on Set the COMP.-YC switch to �COMP� .
Press and hold down the
% (STOP) button on the front panel when no disc is inserted or while the unit is stopped.
�S-VIDEO� appears in the display window after a few seconds.
(Display Window)
VCDVD
PROGRAM RANDOM
TITLE TRACK CHAP
1 A-B
!
Keep holding down the
% (STOP) button on the front panel.
After a few more seconds, �RGB� replaces �S-VIDEO� in the display window. Now the RGB signal can be output when setting the COMP-Y/C switch to �COMP .�
(Display Window)
VCDVD
PROGRAM RANDOM
TITLE TRACK CHAP
1
A-B
�
To make the S-VIDEO jack active, use the similar procedure.
NOTE
� � Do not connect the unit to an NTSC television. Connect it to a PAL television. When the unit is set to feed the RGB signals, the S-VIDEO jack does not feed correct signals.