|
Categories
|
Information
|
Featured Product
|
|
|
 |
|
There are currently no product reviews.
 ;
got exactly what i ordered in a very timely manner. will use again for other manuals
 ;
I'm happy. Good quality. Very helped me with my work..............................
 ;
This is the second Manual I have ordered from owner-manuals, I give it five stars because it is exactly what I expected given the age of the equipment. So the contents look a bit aged and the pictures a bit grainy, it fulfills my needs and I am glad I can still get hold of them.
 ;
thank u so much for this manual that was so cheap that i thought it was a scam but i gambled anyway because it was too good of a deal to pass up and behold,the manual has everything and details of everything even the screws and im still amazed and very happy with my manual .so take my word and jump on it before they realize how cheap they selling thier manuals..thank you so much for taking time to read my thoughts
 ;
I do not have very much to say.
The price is quite covenient, delivery was better as promised (about 12 ours, against the specified 24 hours if I remember well), and the quality of the PDF is more than acceptable.
The Service Manual of Sansui R30 itself is also satisfactory: good graphic for schematics and layouts, simple and well structured.
Giovanni Bianchi
XV-FA92SL
<Loading base assembly unit>
Prior to performing the following procedures, remove the top cover, the front panel assembly, the main tray assembly, the loading base assembly.
Slide gear
Elevator base Shafts
Q
Removing the elevator base (See Fig.18 and 19)
REFERENCE: It is not necessary to remove the traverse mechanism assembly from the elevator base. As the removing procedure of the traverse mechanism, please refer to �Removing the traverse mechanism assembly�. 1. Turn over the loading base assembly and remove the two screws Q. 2. Remove the elevator base upward.
Slide gear
Fig.18
Reattaching the elevator base
REFERENCE: From above the loading base, turn the load base counterclockwise until the slide gear stops at the back end as shown in Fig.19. 1. Reattach the elevator base to the loading base assembly while fitting the two shafts on the side of the elevator base to the grooves of the slide gear. 2. Reattach the two screws Q.
Load base
Fig.19
1-11
|
|
 |
> |
|