This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
Text excerpt from page 113 (click to view)
5
6
7
8
5 AF Assy
8
Reattatch the VIDEO JACK Assy by tighten the two screws.
8 �2
1 2 3 4 5
Remove the bonnet and tray cap. (See Step ¥.) Remove the Front Panel Section. (See Step ø.) Remove the Table Mechanism Section. (See Step �.) Remove the AMP Module Section. (See Step [.) Remove the DVD angle HTM by removing the two screws.
A
DVD angle HTM Rear view
5 5
DVDM Assy
B
9
10
Connect the two jig cables. Arrange the cables as shown in the photo below.
C
9
Jig cable (GGD1315)
9
Jig cable (GGD1315)
6
Remove the four screws. Rear view
6
CN3031 CN3032
D
CN3011 CN3012
6
6
6
Note on handling the rear panel
During diagnosis, be sure NOT to remove the four screws marked A in the above photo. This unit will damage if the Audio Output connectors and the Speaker Output connectors of the AF Assy are separated from the rear panel, because that would damage the ICs in circuit. AMP TRADE Assy 6CH AMP Assy Rear view
E