|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I'm very happy that you all are performing an incredible good job. Furthermore what you did is very useful for all people as me that have electronics as an hobby.Thank you!!!!!
;
Manual found fast and good quality, very helpfull service
;
8-17-12 Been using the sight for about 6 months. Fast Downloads and top quality
Manuels !
 ;
Everything was great, the manual, the response time, the simplicity of the order, and the
Price. The only thing that I could possible say on a negative note would be that the manual I ordered was more for a service tech. There were a lot of schematic diagrams that didn't help me solve the problem. However I would order again and recommend the web sight to others.
;
I'd been looking for this manual for awhile. Exactly what I needed - and at an excellant price. Thanks!
1
2
3
4
A
11 12 13 14
Remove the three screws. Remove the PCB support. Remove the flexible cable and disconnect the connector. Remove the DVDM Assy.
15 16
Connect the two jig cables. Reattatch the three flexible cables(A ) and the one connector (A) from the Table Mechanism Section.
17 12
PCB Support
Remove the soldered joint pickup short point. Reattatch the clamper holder by reattatching the two screws.
18
Flexible cable
Cutting Pliers AF Assy DVD TRADE Assy
13
B
13 11
CN953
14
CN5105
15
CN5107
A
Jig cable (GGD1228)
13
C
11
CN911
11 15
DVDM Assy Jig cable (GGD1222) To DVDM To DVDM CN911 CN953
19 20
D
Insert the insulation sheet between the DVDM Assy and the chassis. Arrange the cables as shown in the photo below.
E
To CN5105
19
Insulation sheet
DVDM Assy
F
120
1 2
XV-HTD530
3 4
|
|
|
> |
|
