Awesome manual. Complete diagrams of all board assemblies as well as how to get to each part of the t.v. down to the individual screws and their locations. Get it.
perfect copy, im very satisfied, i was need the diagram over the powersupply and
the copy was very sharp
Text excerpt from page 95 (click to view)
5
6
7
8
TRAVERSE MECHANISM ASSY-S Disassembly 1 2
Remove the Bonnet (Screws � 11) Remove the Tray Cap Remove the Front Panel Section (Refer to " FRONT PANEL SECTION")
A
8
Unhook
CN12
9 7
TRSB Assy
9
Unhook
B
3 4 5 6 7 8 9
10
Power ON Tray Open (0 OPEN/CLOSE) Pull out the power cord from the outlet. Push the Tray by hand. (about 5 cm) Bring an extra flexible cable close to the rear side. Disconnect the flexible cable. Note : The Traverse mechanism being an unclamp (=down) state.
C
Unhook � 2 Pull out the tray while pressing the two hooks ( 9 ).
10
6
Tray Section
D
When Tray Cannot Pull Out
Tray cannot pull out that is not at a position of home position. (When two hooks ( 9 ) hide under the Rotary Tray and can not pull out the tray.) In that case, set the tray in the following procedures. 1 Remove
3
Tighten
E
Note : Do not need to match with Disc No. (1 to 5) when returns the tray. Detect it automatically.
Rotary Tray
2
Set the tray to the position that can see a hole of the center.