|
There are currently no product reviews.
 ;
Good quality service manual.The scheme is on A3 format and very readable.Thank you
;
Very good service-manual with clear electrical diagrams. Thanks you.
 ;
the manual is in quite good quality and it's in pdf. manual was send in less then 6h.
;
Absolutely top, I've got now all Service-Manuals I'll need to repair my Mackie-Mixer!
;
The service manuel is very helpful, we where able to restore the device to its working operation again.
2.1.5 Removing the rear panel (See Figure 8, Figure 9) � Prior to performing the following procedure, remove the top cover. (1) Remove the six screws E attaching the rear panel. (2) Disconnect the power cord from connector P901 on the power supply board (3) Remove tie band.
Rear panel
E
G G
E
Fig.8
E
CN901 P901
H Tie band Power cord
CN702 Output terminal board
2.1.6 Removing the output terminal board and power supply board. (See Figure 9) � Prior to performing the following procedure, remove the top cover/mechanism assembly/rear panel. (1) Remove the two screws G attaching the output terminal board. (2) Disconnect the card wire from connector CN702 on the output terminal board. (3) Remove the three screws H attaching the power supply board. (4) Disconnect the card wire from connector CN901 on the power supply board.
HH Power supply board Fig.9
1-10 (No.XA003)
|
