|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
very good manual with clear electrical schemes. Very helpful to find wat was wrong inside my microwave.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
2.1.5 Removing the rear panel (See Figure 8, Figure 9) � Prior to performing the following procedure, remove the top cover. (1) Remove the six screws E attaching the rear panel. (2) Disconnect the power cord from connector P901 on the power supply board (3) Remove tie band.
Rear panel
E
G G
E
Fig.8
E
CN901 P901
H Tie band Power cord
CN702 Output terminal board
2.1.6 Removing the output terminal board and power supply board. (See Figure 9) � Prior to performing the following procedure, remove the top cover/mechanism assembly/rear panel. (1) Remove the two screws G attaching the output terminal board. (2) Disconnect the card wire from connector CN702 on the output terminal board. (3) Remove the three screws H attaching the power supply board. (4) Disconnect the card wire from connector CN901 on the power supply board.
HH Power supply board Fig.9
1-10 (No.XA003)
|
|
|
> |
|
