|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I am very happy regarding the online purchase of this manual from Owner-Manuals.com as with this I could set right my Denon CD player and Amplifier.
I once again sincerely thank them for the prompt service which was rendered to me.
N. Shanker
 ;
More than pleased with my prurchase, very good product for the price.
 ;
Manual-link came 30 minutes after having paid for an extremely rare (40 years old) item (sony icr-120) and helped me to get the radio rework again. So really good help for me, fast and reliable delivery and -taken that into consideration- a very reasonable price for that service. So thanks again! Mike, Germany
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
2.1.5 Removing the rear panel (See Figure 8, Figure 9) � Prior to performing the following procedure, remove the top cover. (1) Remove the eight screws F attaching the rear panel. (2) Disconnect the power cord from connector P901 on the power supply board (3) Remove tie band.
Rear panel
F
F
Fig.8
F
G
G
H
CN901
CN731 CN101 CN502
H P901
CN902,CN903 H Servo control and signal output terminal board
Fig.9 2.1.6 Removing the servo control and signal output terminal board. (See Figure 9) � Prior to performing the following procedure, remove the top cover/rear panel. (1) Remove the two screws G attaching the servo control and signal output terminal board. (2) Disconnect the wire from connector CN101,CN502,CN731 on the servo control and signal output terminal board. (3) Disconnect the flat wire from connector CN902,CN903 on the power supply board. 2.1.7 Removing the power supply board. (See Figure 9) � Prior to performing the following procedure, remove the top cover/rear panel. (1) Remove the three screws H attaching the power supply board. (2) Disconnect the wire from connector CN901,CN902, CN903,CN904 on the power supply board. (3) Disconnect the socket wire from socket P901 on the power supply board. 2.1.8 Removing the MIC amplifier board. (See Figure 10) � Prior to performing the following procedure, remove the front panel assembly. (1) Remove the two screws I attaching the bracket. (2) A MIC amplifier board is drawn out. At this time, a MIC volume knob also separates simultaneously.
Power supply board
Front panel assembly
I
I
MIC Amplifier board
Fig.10
(No.XA007)1-9
|
|
 |
> |
|