|
There are currently no product reviews.
 ;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
;
Very pleased with the quality of the scan. No complaints whatsoever.
 ;
I liked the product. I would use their sevices again.
XV-SA600BK/XV-SA602SL 2.2 Loading assembly section 2.2.1 Removing the clamper assembly (See Fig.2-8) (1) Remove the four screws A attaching the clamper assembly. (2) Move the clamper in the direction of the arrow to release the two joints a on both sides. ATTENTION: When reattaching, fit the clamper to the two joints a.
Joint a
Joint a
A
A
Clamper assembly
A
A
Fig.2-8 2.2.2 Removing the tray (See Fig2-9. and 2-10) � Prior to performing the following procedure, remove the clamper assembly. (1) Push b of the slide cam into the slot on the left side of the loading base until it stops. (2) Draw out the tray toward the front. ATTENTION: Before reattaching the tray, slide the part c of the slide cam to the right as shown in Fig.2-10.
Loading base Push b Fig.2-9 Tray
Part c
Slide cam Fig.2-10
9
|
