|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Manual found fast and good quality, very helpfull service
;
8-17-12 Been using the sight for about 6 months. Fast Downloads and top quality
Manuels !
 ;
Everything was great, the manual, the response time, the simplicity of the order, and the
Price. The only thing that I could possible say on a negative note would be that the manual I ordered was more for a service tech. There were a lot of schematic diagrams that didn't help me solve the problem. However I would order again and recommend the web sight to others.
;
I'd been looking for this manual for awhile. Exactly what I needed - and at an excellant price. Thanks!
;
very complete. acceptable resolution. details are a little unclear. is a manual note 8.
TH-A10R/TH-A10
Removing the eject board (See Fig.28)
1. Disconnect the harness from connector CN702 on the eject board. 2. Remove the three screws P board. attaching the eject
Eject board Switch board
P
Removing the LCD board (See Fig.29)
1. Remove the four screws Q attaching the LCD board. 2. Unsolder WA701, WA703 and WA704 on the LCD board.
CN702
T
Fig.28
Q
Removing the IC board (See Fig.27)
1. Remove the screw R attaching the IC board. 2. Disconnect the harness from connector CN706 on the IC board.
WA701 LCD board
Q
WA704 WA703
Q
Removing the LED board (See Fig.27)
Prior to performing the following procedure, remove the LCD board and the IC board. 1. Disconnect the harness from connector CN705 on the power switch board. 2. Remove the two screws S attaching the LED board. Fig.29
Q
IC board
R
CN706 Power switch board
O O
Removing the switch board (See Fig.28)
Prior to performing the following procedure, remove the LCD board.
S
1. Disconnect the harness from connector CN702 on the eject board. 2. Remove the two screws T board. attaching the switch Fig.27
LED board
1-12
|
|
|
> |
|
Home
