|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I searched EVERYWHERE looking for the manual/s on this "extinct" amp. Owner-Manuals.com made it available and for nearly nothing. Thanx to them, I can decipher the unknown cables and sort them out. Thanx, Owner-Manuals.com!!
;
Yes thank you i got the file i was after. There was a slight problem in my communication but it all worked out well.
A job well done.
 ;
Great manual...really saved me. The only problem is that I thought I would be able to download it directly when I paid for it but never received the download instructions until the next morning. The board trace pages were somewhat light also: really need to turn up the contrast on the printer before printing them. The schematic page was great; very clear! Well worth the money.
;
I've been in the electronic business for a long time. I used to buy Sam's Photofact for my needs which intailed having to go to the store and paying about $20 for a package of 3 different units so I was forced to buy more than I needed just to get one.
Owner manual is just at your keyboard and the information is almost instantansouly and the cost is very reasonable. Easy to print out if needed or simply read off of the screen. The larger the screen the better for obvious reasons.
;
Very good manual, at a very good price. Received in a timely manner
1
2
3
4
7.1.2 NOTES ON REPLACE OF PARTS
A
(ID-related) The ID number for an individual product is stored in the EEPROMs (U7 for the TX module, U11 for the RX module) of each module (TX module: AXF7006, RX module: AXF7008). It should be noted that wireless communications cannot be performed unless these ID numbers are identical.
1. Replacement of the TX or RX module
Upon replacement of the TX (AXF7006) or RX (AXF7008) module, remove the EEPROM from the original module and mount it on the new one.
2. Replacement of the EEPROMs (U7 and U11)
Using service part AXX7169 (a kit containing two EEPROMs with identical ID numbers stored in them,) replace both EEPROMs when either needs to be replaced.
B
Note : The AXX7169 is a service part containing two EEPROMs, both of which must be replaced when either needs to be replaced.
7.1.3 DIAGNOSIS OF THE AMPLIFIER SECTION
You can diagnose the amplifier section even if the transmitter section is not available. Input audio signals to the Jumper Wire for service use indicated below. At that time remove the RX MODULE.
W141 LW142 L+
C
W155 R-
VA+9 13 CN3051 1
1 pin
B MAIN ASSY
SIDE A
1 3
Jumper Wire for service for signal input
W127 VREF Ch.SEL
CN3701
W195 W194 W139 W193
L GND R
1 4
W156 R+
W143 GNDP
W126
E
W140 V+9RF
F
60
1 2
XW-HTD630
3 4
3401
4 1
D
PNE-1B1
CN5
CN5901
1
1 12 1 1 12 1 2 13
3
servicefor
Wh
|
|
|
> |
|
