|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
A good and useful manual. With these, We was abled to isolate and pin point the component that was causing the problem. The total time spent in troubleshooting is very much reduced.
 ;
The quality of the manual is top. The transfer worked perfect and fast.
No problems at all. Recommendable
;
Very good service for get any documentation. Fast and perfect quality.
;
Excellent service manual with all the necessary info. :)
;
The product dowload was delivered efficiently with emails to support its download availabilty. The contets of the manual was very eligible and of good quality. Will purchase from this site again!
5
6
7
8
4 AMP Module L-2CH
1
the AMP module L-2CH can be removed without removing the RX module. (Shown as step �.)
A
2
Remove the two screws.
2
Chassis section
3 4 5 6 7
Remove the three screws. Remove the two push rivets. Remove the one screw. Put off the PCB angle for a while. After removing POWER ASSY by removing one screw, remove the AMP Module L-2CH by removing the three connectors. Barrier
3 3
4
3
B
2
Rear view
7 7 7 6 5 7 7
PCB Angle
C
Before shipping out the product, be sure to clean the following positions by using the prescribed cleaning tools: Position to be cleaned Fans Cleaning tools Cleaning paper : GED-008 AMP Module L-2CH
Able to input signals using the jumper wire for service. At that time remove the RX MOD ULE. (Refer to 7.1.3 DIAGNOSIS FOR AMP SECTION)
D
MAIN Assy
CN3305 CN3306
CN3304
REGULATOR Assy
CN3303
CN3301
E
CN3302
8 8
Jig Cable (GGD1335)
Connect the jig cable (GGD1335).
AMP Assy
Diagnosis
F
XW-HTD640
5 6 7 8
63
|
|
|
> |
|
