I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Text excerpt from page 15 (click to view)
HEPA Cartridge Filters and Washable Hepa Filters. (Only for models with HEPA cartridge.)
Check the HEPA �lters each time the dust cup is emptied. Replace twice a year or after every six times the dust cup is emptied.
To remove HEPA cartridge �lters and Washable HEPA Filters
Latch 1. Push down latch and pull �lter cassette back. 2. Then lift �lter up and remove.
Filter Cartridge (One complete unit)
To replace HEPA cartridge �lters and Washable HEPA Filters
1. Place bottom tabs of �lter cassette into slots. 2. Rotate �lter toward cleaner. 3. Push upward on the latch to secure into place. NOTE: To have the bene�t of a sealed HEPA system, you must use one of the HEPA cartridge �lter systems. NOTE: For rinsing instructions of the Washable HEPA �lter see the �Rinsing Directions for Rinsable Filters� on the previous page. CAUTION: If your cartridge does not say �Washable HEPA Filter� it is not reusable � Do Not Wash.
Tabs
Maintenance of Dirt Alert Feature (On some models)
The dirt alert sensor uses infra-red technology to indicate whether or not �oors are clean. When debris breaks the light beam, the red light comes on indicating additional cleaning is needed in this area. If there is no break in the light beam, the �oor is clean and no light will come on. When using your new vacuum you may be cleaning deep down hidden dirt missed by your old vacuum causing the light to stay red longer. With frequent cleaning, after the �rst few times you use your new Electrolux vacuum, the red light should go on less. NOTE: The dirt alert feature is not intended to be used for above the �oor cleaning with attachments.
The red light indicates dirt, dust, etc. is still being removed from the area being cleaned. Hose
How to Check the Dirt Alert Sensors
To check if dirt sensor is working properly. 1. While the red light is on, tip the vacuum backwards on rear wheels, lifting the brush roll off the carpet a couple of inches. 2. After a few seconds the red light should turn off. HINT: New carpeting has loose carpet �bers which will trip the red light sensor beam. Infrared Emitter and Sensor Hose Retainer
15
