This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
Fast and courteous service. Product delivered as described. Thank you.
Text excerpt from page 5 (click to view)
Unpacking the Unit
� Unpack the unit and check that all items that should be included are present. Immediately notify your dealer or our Customer Service department if you find any damage or if any items are missing. � Save the original packing carton, since you can use it for storing the unit and might need it to return the unit to your dealer or an Electrolux Customer Service engineer for servicing.
CAUTION
Never vacuum without the cartridge filter installed. Cleaning the cartridge filter (13) Dismantle the cartridge filter (Fig. E ). You can clean it by simply brushing off the dust, whilst holding it at its handle over a garbage bin. If necessary, you can also clean it under a light flow of running water. In this case, it must be fully dried before being used again. Replacing the Dustbag Replacing the paper dustbag (12) � Fig. C: Switch off the unit, unplug the cable, and remove the motor housing (7) from the tank (1). Grasp the cardboard flap on the paper filter bag (12), pull if off the hose fitting (2), press a new dustbag onto the hose fitting (2), and replace the motor housing (7).
Assembling the Unit
� Fig. A: Open the latches (8), lift off the motor housing (7), and remove the accessories from inside the tank. � Fig. B: Insert the pins (17) into the holes in the base of the tank (1) and then press the castors (9) and pins in the holes until the necks of the castors are flush with the base of the tank. Set the tank (1) down on the castors and check whether the castors are correctly seated and working properly. � Fig. C: a Mounting of parking mechanism (19). b Mounting height of locking mechanism is to be determined depending on the size of nozzles to be inserted (20). � Fig. D: Grasp the paper dustbag (12) by the edges of its cardboard flap, press the bag firmly onto the inner side of the hose fitting (2), and then spread the paper dustbag out against the inner wall of the tank (1). � Fig. E: Place the cartridge filter in an upright position on the motor flange and gently but firmly slide it into place on the filter mounting. The pre-mounted retaining clips automatically snap into place, thus securing the cartridge filter. � Fig. A: Set the motor housing (7) onto the tank (1) such that the switch (3) is above the hose fitting and latch down both latches (8). � Fig. F: Align the index mark on the suction hose (5) on that on the hose fitting (2) and then insert the suction hose (5) into the hose fitting (2) and press it home until the button snaps into the hole. You may now install the accessories you intend to use on the free end of the hose. To remove the suction hose (5), simply give it a twist it and pull off the fitting (2) while continuing to twist it. � Fig. G: Cable storage.
Cleaning the Unit
� Switch off the unit and unplug its cable. Do not use abrasive or aggressive cleaning agents. Wipe the motor housing and tank clean using a damp cloth. � Never use acetone, acids, or solvents for cleaning, since they will attack the units finish and components. � Never immerse the unit in water. � Replace the dustbag at regular intervals. Unplug the unit before proceeding to replace the dustbag.
Disposing of the Unit
� Units that are no longer serviceable may be brought to a public collection point or refuse dump for disposal. � Normal household dust may be disposed of along with other household waste.
