|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Product was very good. Received quickly and complete
 ;
Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
Building-in instructions
Dimensions of housing Model IKE 197-6 IKE 247-6 Height 1030 mm Depth Width 550 mm 560 mm 1225 mm 550 mm 560 mm
50 mm
min. 200 cm
2
Temperature regulation
The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings.
min. 200 cm
2
Fresh food refrigeration
To obtain the best performance: � � � do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it.
For safety reasons, minimum ventilation must be as shown in Fig.
D567
However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: � room temperature; how often the door is opened; the quantity of food stored; location of appliance.
Attention: keep ventilation openings clear of obstruction.
540
50
� � �
B
It is necessary that the niche is provided with a conduct of ventilation having the following dimensions: Depth 50 mm Width 540 mm
PR01
A medium setting is generally the most suitable.
T
H
Important If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear
Slide the appliance into the recess, pushing it against the wall on the handle side.
A
wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption.
Movable shelves
The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired.
D022
Positioning the door shelves
To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required.
D
D338
Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position.
C
D727
PRXXX
Humidity control
The glass shelf incorporates a device with slits (adjustable by means of a sliding lever), which makes it possible to regulate the temperature in the vegetable drawer(s). Close the slots to obtain a warmer temperature and greater humidity. Open the slots to obtain a cooler temperature and less humidity.
PR271
Apply the sealing strip pushing it between the refrigerator and the adjacent cabinet.
D724
16
13
|
|
|
> |
|
