A good and useful manual. With these, We was abled to isolate and pin point the component that was causing the problem. The total time spent in troubleshooting is very much reduced.
The product dowload was delivered efficiently with emails to support its download availabilty. The contets of the manual was very eligible and of good quality. Will purchase from this site again!
Text excerpt from page 22 (click to view)
9. Drive motor disassembly
1 Remove the document table. 2 Remove the top cabinet. 3 Remove the bottom cabinet and remove the drum cartridge. 4 Remove the motor encoder sensor PWB and the encoder. 5 Remove the main chassis and remove the drive unit. 6 Remove the drive motor. (2 screws)
11. Lower heat roller disassembly
1 Remove the document table. 2 Remove the top cabinet. 3 Remove the bottom cabinet and the drum cartridge. 4 Remove the main chassis. 5 Remove the lower heat roller.
12. Heater lamp disassembly
1 Remove the document table and the top cabinet.
10. Power PWB disassembly
1 Remove the document table. 2 Remove top cabinet. 3 Remove the bottom cabenit and the drum cartridge. 4 Remove the main chassis. 5 Disconnect the connectors and the grounding cable (1 screw). 6 Remove the three fixing screws and remove the power PWB.
2 Remove the screw which secures the heater lamp terminal in the
rear side, and remove the heater lamp terminal.
3 Pull out the heater lamp from the rear side.
Note: Do not touch the glass surface of the heater lamp directly with your hand.
@
Note for assembly: When assembling, put the rating indication (e.g., 100V 600W) of the heater lamp towards the front side.