This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
Text excerpt from page 16 (click to view)
Door reversal
1. Disconnect from the electricity supply. 2. Remove all loose items, including food, store food in a cool place. 3. Gently lay the fridge/freezer on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packing; 4. Remove the feet (2-3) 5. Remove bottom hinge (1). 6. Remove the freezer door by releasing it from the middle hinge (H). 7. Unscrew the middle hinge. 8. Unscrew the 2 blanking plastic headed screws from the opposite side. 9. Slide out the fridge door from pin (G), unscrew the latter and then screw it down into the hinge provided on the opposite side, after having removed the small plugs from the top of the doors which should then be fitted on the opposite side. 10.Refit the fridge door and replace the middle hinge to the left hand side. 11.Refit the plastic headed blanking screws into the holes left by the middle hinge. 12.Replace the door and bottom hinge (1) on the opposite side. 13.Refit the feet (2-3) on the opposite side.
G
H
D715 PIED/M
3
1 2
Attention
After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
