|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The delivery of this manual was very fast, less than 8 hours. The manual is very clear and concise, and helped a great deal in the repair and final setup of the Hitachi HMA-G2 Amplifier.
;
Great service. The manual was exactly what I was looking for: schematic + layout. I managed to fix the player. Highly recommended!
 ;
At $5,00 certainly good bang for your buck. Includes electric schematics as well as exploded parts view + parts list for reordering. Unfortunately no details on the PCB contents or working, but then again, this is not overly complex. Best bonus: this manual does contain the heavily searched for LED error codes as well as descriptions for test operation. Haven't gotten around to fixing the machine yet, one thing the manual won't do for you is getting it out of the kitchen assembly :-(
;
It`s not your fault tear down is rather incomplete. It doesn`t have complete instructions as to deconstruction for repair.
;
THANK YOU FOR A GOOD TRANSACTION, NICE COPY, CLEAR
(2) Space around the copier
The copier requires at least 10cm of clearance between the rear side and the wall. This space is required for proper cooling fan ventilation. Adequate working space around the machine should also be allowed for ease of operation.
3 Remove tape (B) and swing the exit tray down. NOTE: Do not place any objects under the exit tray. The exit tray is linked with the fusing rollers inside the copier. When the exit tray is opened, the proper pressure for fusing toner on the paper is applied to the fusing rollers. If there is something under the exit tray and the exit tray is not fully opened during copying, a paper jam or improper fusing may occur.
(3) Power source
1 The power supply line should have a capacity of more than 15A, capable of supplying more than 90% of the rated voltage at full load. 2 Do not use an extension cord, or operate any other equipment from the same wall outlet. 4 Open the box containing the TD cartridge. Remove the TD cartridge from the bag and shake it horizontally four or five times. 5 Remove the cover from the TD cartridge.
�
Save the TD cartridge cover. It should be used to seal the TD cartridge if the copier must be shipped for servicing or if the copier is to be moved. (See page 6.)
(4) Ground connection
1 Use a properly grounded (three prong) wall outlet only.
3. Installation procedure
1 Remove the copier from the bag. 2 Press the buttons on both sides of the copier and open the front cover. Remove tape (A) to remove the spacer where the TD cartridge will be inserted.
6 Slide the TD cartridge in until it locks in place. 7 Close the front cover.
NOTE: Toner/Developer (TD) cartridge is sold separately.
�4�
|
|
|
> |
|
