Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
Text excerpt from page 19 (click to view)
Door reversal directions
1. Disconnect from the electricity supply. 2. Gently lay the fridge/freezer on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packing; 3. Remove the ventilation grill (D). 4. remove the bottom hinge (E) by unscrewing its three fixing screws; 5. Remove the freezer door by releasing it from the middle hinge (H). 6. Unscrew the middle hinge. 7. Remove the fridge door by releasing it from the top hinge pin (G). 8. Remove the pin then mount these on the side, after having removed the small plugs which should then be fitted on the opposite side. 9. using a 10 mm spanner, unscrew the hinge pin (E) and reassemble it on the opposite side of the hinge; 10.Refit the fridge door and replace the middle hinge to the left hand side. 11.reassemble the lower hinge (E) on the opposite side, using the screws previously removed. Slide the hole cover (F) out of the ventilation grille (D) by pushing it in the direction of the arrow and reassemble it on the opposite side; 12.reassemble the door; 13.refit the ventilation grille (D), clipping it into place; The doors can be aligned by adjusting the middle hinge. The middle hinge can be adjusted horizontally, after having slackened the two screws with a screwdriver.
G
PR18
E
F
E
F
F
D F
H
Important
After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
