5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
Text excerpt from page 15 (click to view)
ADJUSTING THE MINIMUM FLAME IN THE OVEN BURNER
� Disconnect the oven from the electricity supply. � Remove the three knobs. � Remove the discharge grid by unscrewing the fixing screws (Fig. 23 - �A�). � Undo the two fixing screws under the control panel and remove it (Fig. 23 - �B�). � With a thin screwdriver adjus the oven tap by-pass pin (Fig. 24 - �C�). Converting the oven from natural gas to LPG, completely tighten the by-pass pin. When reverting the oven to natural gas, first completely tighten the by-pass pin, then unscrew it of about 3/4 of a turn. � Refit the parts by following the procedure backwards. � Connect the oven to the electricity supply. � Light the oven at the maximum positionand let it warm up with the door closed for about 10 minutes, then check that the oven burner does not go out when quickly turning the oven knob from the maximum position to the minimum position. If the oven burner goes out, repeat the whole procedure.
FO 1084
