ZANUSSI ZC280R
Owner's Manual

INSTALLATION
Location
The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm (A). Ideally, however, the appliance should not be positioned below overhanging wall units (B). Accurate levelling is ensured by one or more adjustable feet at the base of the cabinet.

USE
Cleaning the interior
Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. A B Do not use detergents or abrasive powders, as these will damage the finish. ¥ ¥ how often the door is opened; the quantity of food stored; ¥ location of appliance. A medium setting is generally the most suitable. Important If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption.

Operation
NP006

Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the �O� (STOP) position. The appliance will start to operate. To stop operation, simply turn the thermostat knob to position �O�

Electrical connection
10 100 mm

Fresh food refrigeration
To obtain the best performance: ¥ ¥ ¥ do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it.

Before plugging in, ensure that the voltage and frequency shown on the serial number plate can vary by ±6% of the rated voltage.

correspond to your domestic power supply. Voltage For operation with different voltages, a suitably sized auto-transformer must be used. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with the following E.E.C. Directives:

Temperature regulation
The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: ¥ room temperature;

10 mm

Movable shelves
The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired.

- 87/308 EEC of 2/6/87 relative to radio interference suppression. - 73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications. Important: It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation

D040

Positioning the door shelves
To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required.

PR260

14

11