perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Super nice! Good to have a manual in digital format.
Text excerpt from page 17 (click to view)
Door reversal directions
1. Disconnect from the electricity supply. 2. Gently lay the fridge/freezer on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packing; 3. Remove the bottom hinge (3), pin (1) and screw (2); 4. Slide out the fridge door from pin (D), unscrew the latter and then refit it on the opposite side; 5. Unscrew the foot on the left side and refit it on the opposite side; 6. Remove the two screws which mask the holes for fixing the hinge from the left hand side; 7. Refit the door and the lower hinge (turning it 180¡), the pin (1) and the screw (2) as shown in the Figure; 8. Remove the handle and refit it on the opposite side.
D590
D
1 3 2
0 18
°
2
Attention
After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier.
D299
