Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Text excerpt from page 19 (click to view)
Electrical connection
Before making the connection make sure that the energy power available in the user's house is sufficient for the normal supply of this appliance (see rating plate), the unit is correctly connected to earth through a suitable plug and according to the installation country laws. This appliance is supplied with connection cable provided with plug. The plug must be connected to a proper socket. The socket or the omnipolar switch used for the connection must be easily reached with the installed appliance. The applinace is supplied with a plug. The plug has to be connected to an adequate socket. If you wish to directly connect to the mains, you have to interpose an omnipolar switch with a minimum opening between contacts of 3mm, between the unit and the mains, complying with the existing regulations. The yellow/green earth wire must not be interrupted by the switch. The brown live wire (originating from the clamp of the cooker junction box) must always be connected to the phase of the mains supply. In any case, the supply cord must be positioned in such a way as it doesn't reach in any point a temperature higher than 90°C.
Replacement of the supply cable
Should the supply cord need to be replaced, choose only cable types from the following:H07 RN-F, H05 RN-F, H05 RR-F, H05 VV-F, H05 V2V2-F (T90), H05 BB-F (section: 3 x 1 mm2). It is necessary that the yellow/green earth wire is about 2cm longer than the live and neutral ones. After the connection, test the heating elements for about 3 minutes to ensure that they are working correctly.
The manufacturer refuses any responsability in cases where normal safety measures are not observed.
