AEG ZCM700X
Owner's Manual

Fitting the Stability Bracket (Not supplied)
If the cooker has to be installed with a flexible supply pipe, it is necessary that a stability device is fitted. If a stability bracket should be fitted by the installer, these instructions should be read in conjunction with the leaflet packed with the stability bracket.

 1. Place the cooker in itsheight. position intended and mark the cooker
2. Mark 165mm below the cooker height. This is the position of the stability bracket. 3. Fix a large type of stability bracket (using two of the provided five fixing holes) to the rear wall (see the picture below). 4. Pull the cooker towards the rear wall as shown in the diagram. The stability bracket should then come into contact with the rear panel of the cooker (see diagram). Should the stability bracket currently installed not allow the cooker to stand correctly, ask the installer to replace it with the correct type.

28

165 mm REAR WALL