I'm so glad I was able to find a site to download my missing manuals. Very reasonable prices and they kept me informed about the process and I had my manual within less than a day. The only thing I wish was an option is a 100% English version with no spanish or anything. But overall great site.
The manual is complete with excellent quality! One suggestion, show number of pages and weather it is multi-lingual. The AD 600 Manuel is about 76 pages and over half is non English. This results in a larger print job than usually needed. Having this information, one could select the desired pages for printing.
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
Text excerpt from page 4 (click to view)
Changing the opening direction of doors and Panelling
If you wish to change the opening side of the doors proceed as follows: 1... Remove the handles of the doors, if they are side fixing by screws. 2... Take off the plinth pressed on to. 3... Remove the inferior hing taking care for the downer door not to fall off and not to lose the plastic spacer. With a 10mm spanner unscrew the the hinge pin and reassemble it on the opposite side. 4... Lift the downer door off the central hinge. 5... Remove the central hinge taking care for the upper door not to fall off. 6�Take the upper door off the upper hinge. 7�Unscrew the plastic bolts of the opposite side of the place of the central hinge taken out and introduce them in the holes occupied before fy the hinge. 8�Unscrew the axe of the upper hinge and screw it to the hinge on the opposite side. Place upper door. Assemble the lower hinge reinforcement in the opposite side it was situated. For the remaining parts proceed the other way round. Once finished make sure that all joints close perfectly well all around the door and chek that the internal light turns of when the fridge door closes.
How to panel the door:
1... Remove one of the side strips.
If your appliance is provided with metal strips for panelling and you wish to do so proceed as follows:
2... Loosen the screws of the remaining strips. 3... Start putting on the panel where you took off the strip pushing it right up to the end. 4... Replace the strip on this side. 5... Tighten all screws NOTE: The panel dimensions must be 2 mm. shorter than the doors. Maximun thickness of the panel is 4 mm.
