ZANUSSI ZDT5895
Owner's Manual

Prior to Using for the first Time
Do the following steps before using your dishwasher for the first time.

Filling with rinse aid
1. If the display indicator is lit, open the dispenser by pushing button (A). 2. Fill with rinse aid up to the �max.� marking (B). Do not exceed the maximum container quantity of 150 ml! 3. Close the dispenser. 4. Immediately remove any spilled rinse aid, as otherwise foaming can occur. The rinse aid indicator goes out. When using �3in1� products, please see advice in section �Filling with detergent�.

Setting the rinse aid dosage
1. Open the dispenser (A). 2. To increase the dosage (C), turn the dosage arrow to the left using a coin or a screwdriver. The factory setting is Level 3 (ideal setting level 2 - 4). 3. Close the dispenser. For further information see �Something Not Working�.

Filling the salt dispenser
Never fill the salt dispenser with rinse aid or detergent! Use only special dishwasher salt in your dishwasher. Fill with salt as follows: 1. Open the cap (A) of the salt dispenser. 2. Fill the dispenser with water (B). 3. Fill with 1 kg of special salt (C). As a result, approx. 1 litre of water will be displaced. 4. Remove salt from around the opening of the dispenser. 5. Close the salt dispenser by turning the cap until the stop is reached. 6. Immediately run a wash programme to wash away any salt residues. The salt display will go off after 1 or 2 rinse cycles. Do not remove the water feed valve, and do not fill with detergent for any reason. When using �3in1� products, please see advice in section �Filling with detergent�. A

B

C

9