Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
Text excerpt from page 4 (click to view)
OPERATION
Before using
Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger. Dry thoroughly.
Control panel
1 6 5 4 2 3
A
B
A - Pilot light B - Thermostat control knob
To Start the Appliance
Allow the appliance to stand for 2 hours after installation. Plug in the appliance and switch on at the mains supply. Turn the thermostat control (B) to a midway setting (3-4) and adjust the slider control, situated on the back wall of the fridge section, to a midway position between �MIN� and �MAX�. The pilot light (A) will illuminate. Leave the appliance for approximately 4 hours for the correct temperature to be reached before placing food inside. To switch off the appliance turn the thermostat control to position �G�
Use of an air circulation slider control - COOL FLOW CONTROL
Your appliance has an air circulation slider control situated at the rear of the fridge compartment, which controls the amount of cold air circulated through the fridge compartment. When the ambient temperature is between 10°C and 16°C, the slider control should be in the �MIN� position. When the ambient temperature is above 16°C the slider control should be midway between �MIN� and �MAX�. When the ambient temperature is very high (i.e. hot summer days) position the slider control to �MAX�.
Setting the temperature
The temperature inside the appliance is regulated by a thermostat with 6 temperature positions and an �OFF� (G) position. Position 1 = minimum coldness Position 6 = maximum coldness Turn the thermostat control knob to the required position. The intermediate position is usually the most suitable (3-4). The thermostat control knob regulates the temperature both within the fridge and the freezer compartment. The thermostat setting can vary as the temperature inside the appliance depends on the following factors: � room temperature � how often the door is opened � how much food is stored � position of the appliance 4
