This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
It was easy done, and I got exactly what I was looking for.
Text excerpt from page 13 (click to view)
Venting
The hood is more effective when used in the extraction setting (ducted to the outside). Venting kits may be purchased through your retailer or DIY store, and must be ducted to an outside vent of 100mm (4�) minimum.
The ducting used must be manufactured from fire retardant material.
When the hood is ducted externally the charcoal filter must be removed.
KTo Fit the Ducting
1. Open the grille by pressing inwardly on the actuator bolts at each side of the grille, while pulling the grille panel downwards. The grille panel will slide into the intermediate position. Raise the lower edge of the grille forward through 45° angle until the grille becomes detached from the slide mechanism. Align the flat sides on the spigot with the recesses in the top of the casing. Insert and snap fix the spigot into the casing. Connect the ducting to the spigot and make an air tight seal. Remove the charcoal filter.
2.
3.
4.
Recirculation
The charcoal filter (optional extra) must be fitted for recirculation.
