I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
Last week I bought a second hand BAUKNECHT TRK4850 DRYER. It is a professional machine with many programs and switch options. I feared it would be a huge quest to find a manual. I was delighted when I found owner-manuals.com. After payment I received the file to download the next day already. The quality is great. I am very happy. Thanks!
but kindly the distributions of the operating programs not find in the owners manual,can you help me to understand the operating programs instructions thank you
Text excerpt from page 4 (click to view)
Changing the opening direction of doors and Panelling
If you wish to change the opening side of the doors proceed as follows: 1... Remove the handles of the doors. 2... Take off the plinth pressed onto cabinet. 3... Remove the lower hinge taking care for the lower door not to fall off. Using a 10mm spanner, unscrew the hinge pin and reassemble it on the opposite side. 4... Lift the lower door off the central hinge. 5... Remove the central hinge taking care for the upper door not to fall off and not to lose the plastic washer. 6... Take the upper door off the upper hinge. Be carefull not to lose the plastic washer. 7... Unscrew the plastic plugs located on the opposite side of the central hinge and introduce them in the holes occupied before by the hinge. 8... Unscrew the axle of the upper hing and screw it into the hinge on the opposite side. Make sure to fit in the metal washer for blocking. 9... Place upper door. For the remaining parts proceed the other way round. Once finished make sure that all joints close perfectly well all around the door and chek that the internal light turns of when the fridge door closes.
How to panel the door:
If your appliance is provided with metal strips for panelling and you wish to do so proceed as follows: 1... Remove one of the side strips. 2... Loosen the screws of the remaining strips. 3... Start putting on the panel where you took off the strip pushing it right up to the end. 4... Replace the strip on this side. 5... Tighten all screws NOTE: The panel dimensions must be 2 mm. shorter than the doors. Maximun thickness of the panel is 4 mm. 18
