Turns out this was not the manual i was looking for. The concertmate 670 keyboard i have is a "Realistic" model made for Radio Shack and none of the diagrams on the owners manual i received matches up. HOWEVER, I must say the service Owners Manual provides was fast and efficient by being available online. The manual was in good readable condition and easily downloaded.
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
Text excerpt from page 4 (click to view)
Changing the opening direction of doors and Panelling
If you wish to change the opening side of the doors proceed as follows: 1... Take off the plinth pressed onto cabinet. (In some models). 2... Remove the lower hinge taking care for the lower door not to fall off. 3... Lift the lower door off the central hinge. 4... Remove the central hinge taking care for the upper door not to fall off and not to lose the plastic washer. 5... Take the upper door off the upper hinge. Be carefull not to lose the plastic washer. 6... Unscrew the plastic plugs located on the opposite side of the central hinge and introduce them in the holes occupied before by the hinge. 7�Unscrew the axle of the upper hing and screw it into the hinge on the opposite side. Make sure to fit in the metal washer for blocking. 8�Place upper door. For the remaining parts proceed the other way round. Once finished make sure that all joints close perfectly well all around the door and chek that the internal light turns of when the fridge door closes.
How to panel the door:
If your appliance is provided with metal strips for panelling and you wish to do so proceed as follows: 1... Remove one of the side strips. 2... Loosen the screws of the remaining strips. 3... Start putting on the panel where you took off the strip pushing it right up to the end. 4... Replace the strip on this side. 5... Tighten all screws NOTE: The panel dimensions must be 2 mm. shorter than the doors. Maximun thickness of the panel is 4 mm.
