Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
Exactly as described, the full user-manual (145 pages). Perfect.
Text excerpt from page 3 (click to view)
Installation
Positioning
� Place the refrigerator away from direct sunlight and heat sources. � Maintain recommended ventilation - see Fig. 1. � Make sure the refrigerator is accurately levelled turning the adjustable feet in order to avoid vibrations and noises, Fig. 2. � This is a built in design to be aligned with other furniture
Cleaning the interior
� Do not use alcohol or any cleanig product containing alcohol because it can damage the cabinet. � Before using the appliance for the first time wash the interior whith luke warm water and some neutral soap so as to remove the typical smell of a brand-new product arid then dry thoroughly. � Do not use detergents or abrasive powders as these will damage the finish. � Remove security used for transportation.
Fig. 1
Electrical connection
Before plugging the appliance make sure that the voltage and frequency shown on the «Technical Features» correspond to your home supply. It is essential that the appliance be efficiently earthed. For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not grounded, have the appliance connected to a separate ground wire in accordance with existing safety regulations. «THE MANUFACTURER DECLINES TO ACCEPT ANY LIABILITY IF THIS SAFETY RULE IS NOT OBSERVED». Should a change of the suplly cord be necessary, remove the lid of the terminal board acting on «E» and «F» as shown figure 3 in order to gain access to the terminals. Fig. 3.
Fig. 2
Starting � up
� Plug the appliance into the mains. � Make sure the inner light turns on when opening the door. � Turn to intermediate position the knobs of the «temperature regulators»: «A» for refrigerating compartment and «B» for freezing compartment.
