Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
Text excerpt from page 18 (click to view)
Door reversal directions
1. Disconnect from the electricity supply. 2. Remove all loose items, including food, store food in a cool place. 3. Gently lay the fridge/freezer on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packing. 4. Remove the feet (B). 5. Remove bottom hinge (A). 6. Remove the freezer door by releasing it from the middle hinge (H). 7. Unscrew the middle hinge. 8. Slide out the fridge door from pin (G), unscrew pin (G) and then screw it down into the hinge provided on the opposite side, after having removed the small plugs (I) which should then be fitted on the opposite side. 9. Remove the plastic blanking screws from the left hand hinge position, refit to the right hand hinge position. 10 Refit the fridge door and replace the middle hinge to the left hand side. 11.Replace the door and bottom hinge (A) on the opposite side. 12.Refit the feet (B).
G H
D715
B
A B
Attention
After reversing the door check that the gasket is sealing correctly to the cabinet. If the gasket is not sealing correctly, apply warm air to the non-sealing area using a hair dryer set to gentle heat. This will make the rubber more supple and allow it to revert to its original shape and seal correctly.
I
