The service manual when downloaded and printed out was clear and easy to read. The manual is complete with the schematic diagram and technical data. I occasionally require a manual and now having registered with this company I shall order from them in the future.
Text excerpt from page 8 (click to view)
Once the top of the panel has been correctly positioned, �x it through the holes in the bottom bracket, without tightening the screws (Fig. 10). Fig. 10
Once the door has ben correctly aligned, tighten the holding nuts on the �xing brackets and attach the appliance to the adjacent units and the bottom of the work surface (Fig. 12). Fig. 12
D471
Check the position again by slackening the screws and pins then, once the best position has been obtained, fully tighten all the �xings. Cover the visible part of the top bracket on the panel with plastic cover (D), inserting it in the locations provided in the bracket. Fig. 11
D
For a correct installation operation if the base plate is more than 100 mm (for cavity height 820 mm) or more than 150 mm (for cavity height 870 mm) you must cut out the plate as shown in Fig. 13. Fig. 13
