Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
The manual was properly scanned and perfectly readable. The only small problem is that I couldn't use my dear Ctrl + F to find a word I needed.
Text excerpt from page 5 (click to view)
INSTALLATION
Remove all packaging before positioning the machine.
Installing and Securing the Machine Under a Kitchen Unit (Sink-Worktop Unit)
By removing the machine's worktop, you can install it under a close fitting sink unit or a pre-existing top, if the dimensions of the recess correspond to those shown in the picture. Then proceed as follows: Remove the machine worktop by unscrewing the two front retaining screws, pull from the front and slide out the rear slots, lifting the worktop. Insert the machine after adjusting the height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.
570÷600
Positioning
If possible, position the machine next to a water tap and a drain. The sides and the back of the dishwasher can rest against the adjacent furniture or the wall. The dishwasher features fill and drain hoses which can be turned either to the left or the right to suit the installation.
Levelling
Good levelling is essential for correct closure and sealing of the door. If the door does not close correctly, loosen or tighten the adjustable support feet, until the machine is perfectly level.
600
IN05
Caution
IN01
Once the machine has been installed, ensure that it can be accessed easily for servicing.
Adjusting the Worktop
You can move the worktop forward or backward by 25 mm in order to align the machine with other kitchen units. Simply unscrew the two front retaining screws, move the top to the required position and then retighten the screws.
Fitting a Decor Panel on the Door
The door of this machine has frames for fitting a plastic laminate decor panel in the colour required to match the dishwasher with the rest of the kitchen furniture. If you wish to do this you must provide the panel yourself. Widht: 588 mm Height: 586 mm Max thickness: 4 mm
To Fit the Panel
Take the door frame off after removing the retaining screws around the edge. Position the panel, refit the frame and tighten the retaining screws around the edge.
AP01
IN03
Note: The panel should be fitted before positioning the machine.
