AEG ZVR11R
Owner's Manual

Defrosting the freezer
A certain amount of frost will always form on the freezer shelves and around the top compartment. Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. Remove the freezer drawers and place them on top of each other by turning every other drawer one half turn. Put insulating material around the drawers, e.g. blankets or newspapers. The frozen products can also be packed closely together and be kept in a cold location, e.g. in the fridge. Defrosting can be accelerated by placing bowls with hot water (not boiling) inside the freezer. Take out the drain spout and place it in the bottom freezer drawer where water can collect. Loosen the ventilation grille to enable the bowl to fit under the drain spout. Carefully scrape off the ice when it starts to thaw. Use a wood or plastic scraper. Do not use sharp objects as these may damage the interior. When all the ice has melted, clean and wipe the cabinet dry, then push the drain spout back in place. Switch on the cabinet and replace the frozen foodstuff. Never use a hair dryer or other heating appliances to speed up defrosting. Excessive heat may damage the plastic interior, and humidity could enter the electric appliance making it live.

To Change the Light Bulb
The light is switched on automatically when the door is opened. Before replacing the light bulb, disconnect the power plug from the outlet. To replace the lamp in the chiller compartment (only cabinets with two doors), first unscrew the lamp grille with a screwdriver. Use a bulb of the same type, E14 socket, maximum rating of 25 W.

When the appliance is not in use
Disconnect the appliance from electricity supply. Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells.

9

Zanussi 818 15 02--02/5