Turns out this was not the manual i was looking for. The concertmate 670 keyboard i have is a "Realistic" model made for Radio Shack and none of the diagrams on the owners manual i received matches up. HOWEVER, I must say the service Owners Manual provides was fast and efficient by being available online. The manual was in good readable condition and easily downloaded.
6. Start the programme
Before starting the machine check that: q the appliance is plugged in q the water supply tap is turned on q the drain hose is correctly and securely positioned the door and the detergent dispenser drawer are closed. To start the selected programme, press the �Start / Pause� button; the corresponding light stops flashing. Only the �washing� light stays on.
q
10.Opening the door after the programme has started
First set the machine to pause by pressing the �Start / Pause� button. Wait two or three minutes for the door lock to-released. If the machine is already heating, or the water level is above the bottom edge of the door or the drum is turning, it means that the door can not be opened. If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to �O�. After about 2 minutes the door can be opened (pay attention to the water level and temperature!).
11. At the end of the programme
The machine stops automatically. If the (rinse hold) option has been selected, the phase light �End� is on to indicate that the water must be emptied out before opening the door. To do this first turn the programme selector dial to �O� and then to drain programme or spin programme . Release of the lock is indicated by the illumination of the �End� light. Turn the programme selector dial to �O� to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells.
7. Altering a programme
You can alter the programme before it starts. When the programme has started, you can only reset it by turning the programme selector dial to O and then you can select the new programme. The washing water remains in the tub. Start the new programme by depressing the �Start / Pause� button.
8. Interrupting a programme
Depress the �Start / Pause� button to interrupt a programme which is running, the corresponding light starts to flash. Depress the button again to restart the programme.
9.Cancelling a programme
Turn the selector dial to O to cancel a programme which is running. Now you can select a new programme.
