Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
Text excerpt from page 19 (click to view)
� When no more water comes out, unscrew the pump cover and remove it. Always keep a cloth nearby to dry up spillage of water when removing the cover.
Clean the filter using a hard bristle brush. Tighten up the inlet hose.
P1090
P1115
� Remove any objects from the pump impeller by
The dangers of freezing
If the machine is exposed to temperatures below 0°C, certain precautions should be taken. q Turn off the water tap. q Unscrew the inlet hose. q Place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water drain out. q Screw the water inlet hose back on and reposition the emergency emptying hose after having put the cap on again. q When you intend to start the machine up again, make sure that the room temperature is above 0°C.
Important!
rotating it.
� Put the cap back on the emergency emptying hose and place the latter back in its seat.
P1117
Every time you drain the water through the emergency emptying hose you must pour 2 litres of water into the main wash compartment of the detergent drawer and then run the drain programme. This will activate the ECO valve avoiding that part of the detergent remains unused at next washing.
� Screw the pump cover fully in. � Close the pump door.
Emergency emptying out
If the water is not discharged, proceed as follows to empty out the machine: � pull out the plug from the power socket; � close the water tap; � if necessary, wait until the water has cooled down; � open the pump door; � place a bowl on the floor and place the end of the emergency emptying hose into the bowl. Remove its cap. The water should drain by gravity into the bowl. When the bowl is full, put the cap back on the hose. Empty the bowl. Repeat the procedure until water stops flowing out; � clean the pump if necessary as previously described; � replace the emergency emptying hose in its seat after having plugged it; � screw the pump cover again and close the door. 19
Warning
When the appliance is in use and depending on the programme selected there can be hot water in the pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the cover, ensure it is securely retightened so as to stop leaks and young children being able to remove it.
Cleaning the water inlet filter
If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged. It is therefore a good idea to clean it from time to time. Turn off the water tap. Unscrew the water inlet hose.
