|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Once again owner-manual.com has saved the day for me, and come through with the manual I need. I looked other places too, and couldn't find it anywhere. Thank You owner-manual.com!!! You're the BEST!
;
very good quality that can be magnified several times, and it remains readable.
For sure I will return next time the need for a service manual arise.
;
The service manual is really great - thanks to it I was able to install the laser unit and thus "save" my CD-player, which seemed to be impossible before I had the manual.
;
Downloaded the Service manual OK of the Technics Piano and have now repaired it and its going fine. Excellant; thank you for the fine servce. A.M
 ;
This site is working fine! Did buy a manual for SX-EX25L and after a while I could download it and fix the problem. Nice and easy!
7-4. Printer Pin Arrangement Diagram
Connection RD terminal Pin No. 1 Pin No. 15 Connection Character selective magnet column No.1 13
(Not used)
2
16
Character selective 3 magnet column No.1 2 4
17
14
18
15
3 4
5 6
19 20
16 17
5 6
7 8
21 22
Ribbon shift magnet Electromagnet (+)
Notes: 1. Column numbers match the physical arrangement of the columns on the print wheels. 2. Column numbers are assigned from 1 to 18 from the frame motor side. 3. Pin numbers are assigned from 1 to 27 from the frame motor side. 4. The spark arrestor diode is connected as shown below.
7
9
M
23
Motor power supply (+) Detector power supply (+) Timing signal Detector power supply (�)
8
10
24
Electromagnet (+)
Driver
9
11
25 26
10
12
(Example of compatible diode: 1S2075K or equivalent)
11
13
27
Motor power supply (�)
12
14
Motor power ON/OFF
*1
0.2ms max.
Timing signal
*2 8.0ms min.
T0
T1
T2
T3
T4
T5
T6
T7
T8
T9
T10 T11 T12
TS
T(0)
0.7ms max. 8 0.7ms max. 0.7ms max.
0.7ms max.
80.0ms min.
2.0ms min.
Character selective magnet No.n Ribbon shift magnet
(Print operation) (Normal paper feeding operation)
Typ. 285.7ms
Notes: 1. The signals in must be prepared by the user. 2. The pulse is indicated by a dot-dash line (*1) is generated for continuous printing. The next print cycle can start immediately after the leading edge of the timing signal Ts. 3. As shown by a dashed line (*2), the timing signal may go low at motor power-on or upon reception of a Print command. �9�
|
|
|
> |
|
