|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great manual, thank you, sony kp46s3 service manual perfectly, i am very happy.
;
Complete original Service Manual in good (scan) quality!
;
Very good manual. Plenty of service information including alignment instructions. Clear circuit diagram. Excellent, thank you.
 ;
Good morning, the service manual you sent me was perfect.
Your service and answering are excellent.
I recomend this service.
Best regards.
;
I had been looking everywhere for a proper service manual for this VCR. Everywhere else that has this available for download has a very light version. This is the full service manual with all aspects that would interest anyone looking for the service manual for the AIWA HV-MX100 Worldwide VHS VCR. Great quality (as always). A winner hands down. Best Quality.
Note: Perform the operation in numerical order.
User's unit Operation 1 While pushing down RESET button, press then release RESET button. 4 Press OK . Display T? (Unit emits a buzz.)
Back up unit Operation 2 While pushing down RESET button, press then release RESET button. 3 Press OK . Display R? (Unit emits a buzz.)
T? (Unit emits a buzz.) OK!
R? (Unit emits a buzz.) OK?
5 After the data transmission.... It takes a few minutes to complete the data transfer.
6 When the data is transferred properly...... In case the data transfer ends incomplete......
NG! or RESET? RESET?
7 Press RESET button. 9 Press ON .
RESET?
8 Press RESET button. 0 Press ON .
USED Note: Never press OK as it deletes all the data.
FREE Note: Never press OK as it deletes all the data.
USED
FREE
5250 60220
The above example is DC-8500 display. The numbers vary depending on the quantity of data.
5250 60220
The above example is DC-8500 display. The numbers vary depending on the quantity of data.
A Press ON (OFF).
B Press ON (OFF).
TROUBLESHOOTING
Before doing the following solutions, save data if possible.
SYMPTOM No power
CAUSE Weak battery Poor soldering of the power supply circuit
SOLUTION Replace batteries Resolder
No display at all or wrong display
Defective heat seal Defective LCD
Replace the heat seal Replace the LCD
�4�
|
|
|
> |
|
