|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
very good manual with clear electrical schemes. Very helpful to find wat was wrong inside my microwave.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
Note: Perform the operation in numerical order.
User's unit Operation 1 While pushing down RESET button, press then release RESET button. 4 Press . Display T? (Unit emits a buzz.)
Back up unit Operation 2 While pushing down RESET button, press then release RESET button. 3 Press . Display R? (Unit emits a buzz.)
T? (Unit emits a buzz.) END
R? (Unit emits a buzz.) END
5 After the data transmission.... It takes a few minutes to complete the data transfer.
6 When the data is transferred properly...... In case the data transfer ends incomplete......
NG! or
7 Press RESET button. 9 Press . USED Note: Never press as it deletes all the data. FREE
8 Press RESET button. 0 Press . USED Note: Never press as it deletes all the data. FREE
5250 60220
The above example is DC-8500RS display. The numbers vary depending on the quantity of data.
5250 60220
The above example is DC-8500RS display. The numbers vary depending on the quantity of data.
A Press
(OFF).
B Press
(OFF).
TROUBLESHOOTING
Before doing the following solutions, save data if possible.
SYMPTOM No power
CAUSE Weak battery Poor soldering of the power supply circuit
SOLUTION Replace batteries Resolder
No display at all or wrong display
Defective heat seal Defective LCD
Replace the heat seal Replace the LCD
�4�
|
|
|
> |
|
|
Parse Time: 0.256 - Number of Queries: 129 - Query Time: 0.051
