|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good service-manual with clear electrical diagrams. Thanks you.
 ;
the manual is in quite good quality and it's in pdf. manual was send in less then 6h.
;
Absolutely top, I've got now all Service-Manuals I'll need to repair my Mackie-Mixer!
;
The service manuel is very helpful, we where able to restore the device to its working operation again.
;
Great quality complete service manual!!! complete parts list and drawings
Troubleshooting
Flowcharts and Tables
Table 11. Power Supply Failure (+24 VDC)
Step 1 Check Switch off the printer. Connect a multimeter between P11-12 (+24 VDC, orange wire) and P11-2 (GND, black wire) on the DC controller board. Switch on the printer. Is the voltage approximately +24 VDC? Switch off the printer. Connect a multimeter between P11-10 (+24 VDC, brown wire) and P11-2 (GND, black wire) on the DC controller board. Switch the printer back on. When you open and close the front access door, does the voltage measure 0 VDC with the door open and +24 VDC with the door closed? Switch off the printer. Connect a multimeter between P11-11 (+24 VDC, brown wire) and P11-2 (GND, black wire) on the DC controller board. Switch the printer back on. When you open and close the front access door, does the voltage measure 0 VDC with the door open and +24 VDC with the door closed? Result No Action Replace the power supply.
2
Yes
Replace the DC controller board.
3
Yes
Replace the DC controller board.
3
No Replace the power supply.
|
|
|
> |
|
