|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
58911Agb.fm5 Page 10 Thursday, February 8, 2001 11:44 AM
BEFORE USING THE GLASS CERAMIC HOB
� To make the most of your new appliances read the users instructions carefully and keep them on hand for consultation in the future.
INSTALLATION
Cooktop
� The cooktop must be set into a worktop between 20 mm and 50 mm thick. � The distance between the lower face of the glass ceramic hob and the cupboard or separating panel must be at least of 90 mm. � If the cooktop is to be installed next to a column unit, leave a distance of at least 100 mm from the edge of the cooktop to the side of the column unit. � Cut an opening in the worktop of the dimensions shown in the Product Description Sheet supplied separately. � If not already present, fit the supplied seal to the cooktop flange after cleaning the contact area as shown in the figure. N.B.: Remove the protective film before installing the cooktop. � If the worktop is made of wood, use the supplied spring clips and screws. 1. Position the 4 clips (D) as shown and at the specified dimensions. 2. Secure the clips using screws (E). 3. Fit the cooktop into the worktop. � If the worktop is made of marble, plastic, ceramics, natural stone, etc., the cooktop must be secured with brackets (F) code 4819 404 78697 (to be requested from After-Sales Service). 1. Fit the cooktop into the worktop. 2. Position the 4 brackets (F) as shown in the figure, in accordance with the thickness of the worktop. 3. Fix the 4 screws (G) in holes (H).
10
|
|
|
> |
|
