|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
ASSEMBLY
Fitting the loop handle
(325Cx)
Assembling and dismantling the two-piece shaft
(323LD, 325LDx)
�
Position the handle on the shaft. Note that the handle must be mounted below the arrow on the shaft.
Assembly:
� Make sure the knob is loose.
� �
Fit the screw, securing plate and wing nut as shown in the diagram. Tighten the wing nut. � Align the cut-out in the lower part of the shaft with the coupling locking tab on the upper part of the shaft. Then lock the sections together. Tighten the knob.
Fitting the loop handle
(323L, 323LD, 325Lx, 325LDx)
�
�
Clip the loop handle onto the shaft. Note that the loop handle must be �tted between the arrows on the shaft.
Dismantling:
� Undo the knob (at least three turns).
� �
Slide the spacer into the slot in the loop handle. 323L/323LD: Fit the nut, washer and screw. 325Lx/325LDx: Fit the nut, knob and screw. Do not overtighten.
� � �
Push the knob towards the coupling. Carefully twist the lower half of the shaft to unlock it. Hold both parts of the shaft and pull the lower part of the shaft out of the coupling.
�
Now adjust the trimmer to give a comfortable working position. Tighten the bolt/knob.
10 � English
|
|
|
> |
|
